Serious motorcycle riders enjoy gathering at special events near their city or maybe in their state or even on an extended road trip. These events may range from social gatherings to huge fund raisers. To commemorate these events patches are purchased as keepsakes. Often the patches are attached somehow to their favorite apparel as being a keepsake to show where they are or who they already have sponsored. How these Custom Biker Patches are attached to apparel needs special attention.
I saw a YouTube demonstration using super glue to install the patch on the leather motorcycle jacket. The property owner of your patch and jacket was careful (obviously when working with super glue) to set the patch in a key position. He placed a type of glue (across the backside edge only) in the patch and after that held it set up. Then a patch was checked by attempting to peel it well. Anywhere it came loose was re-glued. Well, it adhered sufficiently for the time being because his next statement was that the patch should be checked often and maybe a touch up might be necessary. And, this could only last a couple of weeks! Generally seems to me, basically if i liked the patch enough to put it on my own jacket, this will not be the instructions to go by. It’s quick, having said that i wouldn’t wish to lose my patch!
Possibly the better choice would be to sew the patch in the leather biker vest or jacket. The simplest way (although maybe not the most cost effective) is to accept it to your shoe repair center or seamstress that really works with leather on a regular basis and also have them practice it for you. Or surely do it yourself with some effort.
If you want to do it yourself, here are a few tips to keep in mind!
In the event the patch is of real value for your needs then you’ll want to sew it in place. Understand that when you sew, you set tiny permanent holes in your leather biker vest or jacket.
Choose where you wish to place your patch. A suggestion for you at this point is always to lay the garment as flat as you possibly can and attach it using 3M adhesive spray. Place the garment on, have somebody go on a picture and after that decide if that is the place you want it! If you choose to move it… Goo Gone enables you to remove all glue marks.
Lay the garment as flat as you can and ensure you can find no creases beneath the patch. The adhesive spray should keep the patch in position as you may sew.
Decide if you are planning to sew through both lining and also the leather or just the leather. It is possible to carefully remove bottom stitching of lining to do business with leather only after which re-sew afterwards. If you opt to undergo both be sure the lining doesn’t pucker a lot of or distort the way the vest or jacket fits. A word of caution: This is especially important when sewing patches on sleeves. The lining has extra material for elbow bending. If it is pulled up very far, the feel of sleeve length changes.
You need to use 100% nylon thread or 100% polyester thread. This particular thread will not likely interact with the tanned leather (cotton thread tends to rot). Call or check at the local 26dexgpky store for the sort of needle (for machine or hand sewing) that is perfect for this project. Make certain, if you’re using a sewing machine that it may get through all materials without breaking the needle.
If you’re stitching manually, use a loop stitch that follows the advantage of the patch. Knot the end and begin through the back. When you’ve followed the edge all the way around, work with a slip knot on front and again on underside. Depending on what color thread you get, this makes an invisible stitch! If using a machine, sew just within the patch border. To get a neater look, tend not to back stitch. Rather, stitch over regarding a half inch in the initial stitches.